![]() ![]() If you don’t want Resilio Sync to track some files in your sync folder, please use IgnoreList. Ignore some files/folders synchronization This is easily fixed by mkdir ~/.rslsync, or whatever your storage_path is set to. If you start the service but cannot reach the WebUI, check the unit status for the system-wide instance or the user unit.Ī common error is Storage path specified in config file does not exist. This is done independently from the creation of the configuration file. The script also creates the storage_path directory set in the configuration file if it does not exist. Rslsync_rvice creates ~/.config/rslsync/nf if it does not exist, and guesses some default values of the settings: Individual users can then enable the rslsync_rvice user unit. Although defeating most of its purpose, rvice can be disabled. The install script enables the service for all users by default. If your $UID is "1000", the port will be 8889. ![]() Rather than 8888, the port for the user's instance of rslsync will be 7889 + $UID. Note: If the configuration file was generated by rslsync AUR it will be configured with a different port. You will probably want to change some of the settings, including: # rslsync -dump-sample-config > ~/.config/rslsync/nf You should review the configuration settings especially user and password, see below.Ī sample configuration file can be created using: You can also run it as the rvice system user (without the -user flag).Ĭonfiguration for this user is located at /etc/nf, and metadata is saved in /var/lib/rslsync/ by default.
0 Comments
Leave a Reply. |